Tip for Difficult to Disconnect Tow Bar Setup from Towed Vehicle
Question:
I purchased the Etrailer tow bar for my motor home and attached the adapter bar to the base plate and now I can not remove the drawbar and adapter bar? What can I do to fix this or is there a fix?
asked by: Larry C
0
Expert Reply:
Try and make sure your tow bar is perfectly square with the direction of travel so that there's no binding between it, your tow vehicle, and your towed vehicle. Typically when what you described happens it's just a matter of getting everything as straight as possible to relieve any tension.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Roadmaster Crossbar-Style Base Plate Kit - Removable Arms
- Base Plates
- Removable Drawbars
- Hitch Pin Attachment
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can TorkLift Locking FastGun Turnbuckles Be Used on Rear Bumper Mount Tie-Downs
- Q&A: Can HappiJac Swing-Out Extender Brackets Used with Northern Lite Factory Installed Dually Brackets
- Q&A: Is There a Weight Capacity for TorkLift Locking FastGun Turnbuckles
- Q&A: Will HappiJac Extender Brackets Put Excess Stress On Camper And Jacks
- Q&A: Draw-Tite Hitch Receiver and Curt Wiring Harness for a 2022 Lexus RX 350
- Q&A: Can I Use the Dexter Replacement Master Cylinder for Disc Brakes to Replace an A60 UFP Actuator
- Q&A: Correct Replacement Step Motor for 59734-20
- Article: Trailer Hitch Receiver Sizes
- Article: Base Plate Adapter Table
- Article: What Is a Supplemental Braking System?
- Article: Flat Towing Package for 2014-2018 Jeep Grand Cherokee
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Roadmaster Vehicle Specific Base Plates