Correct Bearing Cap Replacement That Has An Outside Diameter Of 1.96 To 1.97 Inches
Question:
I cant find the correct size bearing cap after one fell out. A brand new 1.98 OD cap is too large. My existing bearing cap has an OD of 1.96-1.97. What model bearing would this be
asked by: Brenden F
0
Expert Reply:
If a grease cap like Grease Cap, 1.988" OD Drive In # RG04-020 is too big, then the Grease Cap # TRAG-DC-196 may be a good fit; this has an outside diameter of 1.957".
Other than that, we do not carry a grease cap that matches your estimated OD.
expert reply by:
Bryce D
0
Products Referenced in This Question
Grease Cap, 1.988" OD Drive In - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- Standard Grease Cap
- 1.98 Inch O.D.
- TruRyde
more information >
Product Page this Question was Asked From
Grease Cap - 1.957" Outer Diameter - Drive In
- Trailer Bearings Races Seals Caps
- Caps
- Standard Grease Cap
- 1.957 Inch O.D.
- TruRyde
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Grease Cap For 1.95 Inch Trailer Hub Bore
- Q&A: Grease Caps With Outer Diameter Smaller Than 1.988 Inches
- Q&A: Electric Drum Brakes To Hydraulic Disc Brake Conversion Kit For 7,000-lb Axles
- Q&A: How to Convert to Disc Brake Kit on 5th Wheel with 7K Tandem Axles
- Q&A: Grease Cap Recommendation for Hub Bore of 1.96 inch
- Q&A: Replacement Grease Cap That Fits a 1.95" Hub Bore Center On Older Trailer
- Q&A: Grease Cap Recommendation to Replace Cap that Measures 1.90 Inches
- Article: Trailer Maintenance Schedule
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Troubleshooting Brake Controller Installations
- Article: Best Camper Jacks
- Article: How to Measure for Trailer Hitch Drop