Troubleshooting Brake Controller Where It Shows Flashing Connection
Question:
My Prodigy break controller has worked very well until recently. Now as soon as you turn the switch on in my 2011 Chevrolet silverado 1500 the break controller shows breaking and fluctuates on power with no trailer connected to the truck. Thought it was a bad controller, purchased a new one. Installed new wiring harness and the new one does the exact same thing.
asked by: Ronnie G
Expert Reply:
Sounds like you have a wiring issue at the 7-way at the rear of your vehicle. Most likely this is just due to corrosion which can be easily cleaned off with sandpaper but it could also be exposed wire on the back of the 7-way that is touching which would cause a short.
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Parts Needed To Install A Brake Controller On A 2023 Freightliner Cascadia
- Q&A: Brake Controller Recommendation for a Truck with Air Brakes and a Trailer with Electric Brakes
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Parts Needed to Install 7-Way/4-Way on 2024 Kia Telluride with LED Taillights
- Q&A: How do I Tell if the Brake Controller is Bad
- Q&A: How Is Spring Bar Tension Set Up with Trailer Weight Distribution System