Replacing a Reese Weight Distribution Shank with a Shank with a Taller Rise
Question:
I need a shank with a higher rise than my reese 54970 shank. Can I use this shank with the Reese ball mount that I have? Thanks
asked by: Jim L
Expert Reply:
The Fastway e2 Weight Distribution Shank, # FA92-02-4213, will work with your Reese weight distribution head. This shank and your Reese shank # RP54970 have the same width, bolt hole spacing and diameter.
Typically, we recommend using a shank from the same manufacturer as your weight distribution system because weight distribution manufacturers do not test their products with products from other manufacturers.
For a Reese weight distribution shank with a taller rise, I recommend using the Reese Weight Distribution shank RP3215. This shank has an 11-1/2 inch rise with trunnion bar weight distribution systems and a 10-1/4 inch rise with round bar systems.
To determine the exact rise that you will need, I attached an FAQ article on choosing the correct ball mount for you to review. This FAQ tells how to measure to determine the exact rise or drop you would need in a ball mount.
Products Referenced in This Question
Reese Weight Dist Shank - 12-1/4" Long - 2" Drop to 6-1/2" Rise - 1,500 lbs TW
- Accessories and Parts
- Weight Distribution Hitch
- Shanks
- Fits 2 Inch Hitch
- Round - 2 Inch Drop
- Trunnion - 1 Inch Drop
- Round - 5 Inch Rise
- Trunnion - 6 Inch Rise
- Reese
more information >
Product Page this Question was Asked From
Fastway e2 Weight Distribution Shank - 12" Long - 7-3/4" Rise, 5-1/4" Drop - 1.2K TW
- Accessories and Parts
- Weight Distribution Hitch
- Shanks
- 1500 lbs TW
- 15000 lbs GTW
- Fits 2 Inch Hitch
- e2
- Round - 5 Inch Drop
- Trunnion - 3 Inch Drop
- Round - 7 Inch Rise
- Trunnion - 7 Inch Rise
- Fastway
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Would Switching a Weight Distribution Shank to A longer One Change the Height of a WDS
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Is 8 inches From Bottom of Weight Distribution System to Ground Enough Clearance
- Q&A: Measurements to Top Hole on Fastway e2 Weight Distribution Shank
- Q&A: Will the 18 Inch Long Equal-i-zer Weight Dist Shank item # EQ90-02-4500 Work w/ the E2 System?
- Q&A: Is Curt Weight Distribution Shank #17100 Compatible with Fastway Weight Distribution
- Q&A: Replacement Hardware for Fastway e2 Weight Distribution Head
- Q&A: Dimensions of the Convert-A-Ball Cushioned Weight Distribution Shank # AMAC1
- Article: How to Drain an RV Water Heater
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Couplers
- Article: How Does a Trailer Hitch Coupler Work?
- Article: How Much Solar Power Do I Need For My RV?
- Article: How (and Where) to Connect an RV Propane Grill