Curt C74VV Venturer Brake Controller Installed on 2006 GMC Sierra Not Getting Power
Question:
I am hooking up the curt brake controller to my 2006 g m c Sierra I plug the adapter wire into the factory block under the dash and then into my brake controller but have no power to the brake controller looked at the external fuses under the hood but cannot figure out which one it is the ones I check are all good. Do you have any ideas for me
asked by: Ron J
Expert Reply:
GM didn't always complete the power feed to the brake controller plug under the dash. No worries, the procedure is pretty simple. Remove the cover from the fuse block under the hood, there will be an outer and an inner cover. Located the threaded stud on the inboard side of the fuse box, there's two of them, you're wanting the one closest to the firewall. Make sure the green 30A fuse is installed next to the stud, as shown in the provided photo.
You'll want to find a red wire with a ring terminal on it, it'll usually be located between the fuse panel and the fender or between the fused block and the firewall. You'll want to install that wire on the threaded stud I mentioned above. With the wire installed on the stud and the fuse in place, the brake controller will power up for you.
I've also linked to a help article that describes the process.
Product Page this Question was Asked From
Curt Venturer NEXT Trailer Brake Controller - 1-3 Axles - Time Delayed
- Trailer Brake Controller
- Time Delayed Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 3 Axles
- LCD Display
- Up to 360 Degrees
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: 7-Way Trailer Wiring Harness for 2024 Hyundai Santa Cruz
- Q&A: How Does Curt TriFlex NEXT Brake Controller Mount
- Q&A: Complete Tow Package For A 2024 Kia Telluride LX
- Q&A: Mounting Panel For Redarc Tow-Pro Liberty on 2007 Toyota Tacoma
- Q&A: Parts Needed to Install the Prodigy P3 Brake Controller on a 2024 Honda Pilot
- Article: Trailer Wiring Diagrams
- Q&A: Which Connector Is Needed To Install Curt Spectrum Trailer Brake Controller On a 2018 VW Atlas?
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Troubleshooting Brake Controller Installations
- Q&A: Recommended Trailer Wiring for 2024 Kia Telluride LX
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Using a Portable Generator on RV