Weight and Sway Distribution Hitch For 2013 Camplite Trailer And Aluminum Frame

Question:

I measured my trailer tongue from the coupler back. Can you clarify if it will work with that measurement?

asked by: Dawn P

Expert Reply:

Due to the front section of your trailer A-frame you will need to use a Pole-Tongue Adapter # EQ95-01-5950 that needs to be mounted between 27-32" back from the hitch ball center. You will need to check and see if this will fit with your propane tank and battery mount bracket on your 2013 Camplite Trailer. The bracket will fit frames up to 5" wide and 5" tall which looks like your frame is under those dimensions.

The next issue I see is your tongue jack. It will likely no longer be able to rotate and run parallel with the trailer frame. with the Fastway e2 Weight Distribution # FA92-00-0600 installed. Once you have the location for your Tongue adapter determined the overall width of the adapter is 21-1/2 inches. This will help you determine where the the spring bars will sit in relation you your jack, breakaway battery and 7-way junction box.

The Fastway e2 Weight Distribution # FA92-00-0600 will allow you to backup with the hitch attached and provide you a safe ride as you drive to your favorite campgrounds.

If you still cannot determine if the whole system will work on your Camplite, please send me some pictures of the measurements and placement I mentioned with the tongue adapter.

expert reply by: Bud M

Customer Image 1
(click to enlarge)

Customer Image 2
(click to enlarge)

Customer Image 3
(click to enlarge)

Dawn P.

1/1/0001

I measured my trailer tongue from the coupler back. Can you clarify if it will work with that measurement?

Gregory M.

9/23/2021

You will be able to mount the Pole-Tongue Adapter # EQ95-01-5950 at the 27-32" measurement that you need on your trailer tongue. You may be able to leave your propane tank where it is but the tongue jack will definitely need to be relocated.