Diagram Of Mounting Holes For Redarc Smart Start Battery Isolator 331-SBI12D
Question:
I need a diagram of the mounting holes for the SBI12D. I am replacing a Cole-Hersey 48525 and want to see if I can use the same mounting holes or at least the same mounting block in my Class C RV.
asked by: Bill F
0
Expert Reply:
As you can see in the attached photo, the Redarc Smart Start Battery Isolator - Dual Sensing - 12 Volt - 100 Amp # 331-SBI12D has bolt holes that are 2-1/8" from each other.
expert reply by:
Andrew N
0
Redarc Battery Isolator Bolt Holes
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Redarc Smart Start Battery Isolator - Dual Sensing - 12 Volt - 100 Amp
- Battery Charger
- Battery Isolators
- 12V
- Vehicle Battery to Auxiliary Battery
- Redarc
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Battery Isolation Manager for Precision Circuit BIM 160
- Q&A: Recommended Battery Isolator for 220 Amp Alternator in Class A Motorhome
- Article: Most Popular Wheel Bearings
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: What Is The Maximum Intermittent Amp Rating For The Bulldog Winch 500 Amp Shut-Off Switch
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Will 350-Amp Bulldog Winch Quick-Connect Work With 175-Amp Quick-Connect
- Q&A: Winch Recommendation for Pulling Racecar Up Into Trailer
- Article: Testing Breakaway Systems
- Article: Trailer Wiring Diagrams
- Q&A: Wiring diagram for Battery Isolator
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Measure for Trailer Hitch Drop