Troubleshooting Lipper Leveling System That Has Flashing Lights And Warnings
Question:
on lippert control panel all the lights are flashing on and off wait, jack down, low voltage ect..
asked by: John S
Expert Reply:
You will want to tell me your model number so that I can accurately determine any possible solutions. That said, I was able to pull some info from Lippert's popular leveling systems to get you started. It is possible that your battery voltage is lower than optimal level, which could cause some of these warning lights. I would first make sure the battery is in good working order. Next step would be to reset your system. If you have a 2009 - present Lippert leveling system then to reset the system you would just push all 4 diamond-shaped jack buttons at the same time.
If you actually have something like the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC358590 which uses Control Panel # LC421484, then this is the process to reset:
1. Press the “CONNECTED” icon at the top of the leveling screen quickly 6 times. Wait a few seconds until the gear icon with "OPTIONS" appears
2. Press the gear icon with "OPTIONS"
3. The screen will show "SET UP: Zero Mode Press Enter"
4. Press the “Enter button”
5. The touch panel will present options for further leveling of the trailer if needed. The screen will also state "ZERO POINT CALIBRATION - Press Enter to Set"
6. Press "ENTER"
7. Screen will show "Zero Point Stability Check ... Please Wait", followed by "Zero Point Set"
Products Referenced in This Question
Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Control Panel
- Lippert
more information >
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Troubleshooting Lippert Leveling System That Flashes Red When "Hitch Height" Button is Pushed
- Q&A: How to Remove Stuck B&W Companion Slider # BWRVK3400
- Search Results: hitch lock
- Shop: Bulldog Lifelong Trailer Coupler Lock - Trigger Latch Style - 1/4" Pin Diameter - Chrome
- Article: Anti-Rattle Devices
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Can I Install a 4-Point Control Module to a 6-Point Lippert Ground Control and Only Use Four Jacks?
- Article: How to Raise Your Travel Trailer Height
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)