Is Soldering The Best Way to Keep Wires Attached For 3376391100 Rocker Switch
Question:
How do you recommending ensuring a good connection is made with this switch? Looking at: 3376391100 Do I need to solder the wires to the leads hard to do this in my RV in the confined space it is in, or is there an easier way to make sure the wires stay attached to the metal leads on this switch?
asked by: Jason H
Expert Reply:
To get the best connection with the wiring, soldering would be the way to go for the Buyers Mini Round On/Off Rocker Switch w/ Bezel - Backlit # 3376391100.
That can certainly be a pain though, so you can also use spade terminals for the switch that will be easier for you and still give you a solid connection. I have added a link below to a video review for you to check out as well.
Product Page this Question was Asked From
Buyers Mini Round On/Off Rocker Switch w/ Bezel - Backlit
- Accessories and Parts
- Wiring
- Switches
- Rocker Switches
- Buyers Products
more information >
Continue Researching
- Q&A: Can A 2-Wire LP Detector Replace A 3-Wire LP Detector
- Q&A: Can Progressive Dynamics 4500 Series Inteli-Power Converter PD4560K18LS8 be Used with AGM Batteries
- Q&A: EZ Loader Trailer Replacement Snap-Ring Swivel Trailer Jack
- Q&A: Recommended Trailer Jack For Trailer With 800 Lbs. Of Tongue Weight
- Q&A: Trailer Wheel Seems Stiff, Not as Easy to Turn After Repacking Bearings with Grease
- Q&A: What is the Bolt Pattern for Brake Mounting Flange 4-50
- Q&A: Possible Replacement for Trostel 300-156-6 Seal
- Article: How to Wire an Electric Winch
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)