Air Lift Wireless Remote Control Replacement For Remote 73001 and Pairing Instructions

Question:

Is 73002 the replacement for 73001

asked by: Matt P

Expert Reply:

I spoke to Air Lift to confirm and the Replacement Wireless Remote AL73002 will work as a replacement for your 73001 remote.

You will need 3-AAA Batteries # 287-11407 that are not included to power on the new remote.

Once you place the batteries into the remote it will enter join mode. Here is how you will join the remote to the manifold.

JOINING THE CONTROLLER TO THE MANIFOLD

• Set the manifold into join mode.
• Ground the join wire in the electrical harness.
• Locate the YELLOW join wire with heat shrink on the end in the harness.
• Remove the yellow wire from the cap leaving the cap attached to the harness.
• Attach the exposed terminal to a good frame ground.

• Cycle power to the manifold.
• Manifold will boot in join mode and will click the exhaust solenoid 5 times fast, then 1 per second.
• The manifold will stay in join mode for 30 seconds allowing time to set the controller into join mode.

• Set the controller into join mode.
• Press UP and DN buttons together to enter settings mode.
• Press the M1 button when the display flashes “JOIn”.
• Use the up and down buttons to select which manifold to join with.
• JOIn r = Join with the manifold controlling the rear axle springs.
• JOIn F = Join with the manifold controlling the front axle springs