Where is the Brake Brake Controller Adapter Port on a 1996 Ford F-53 Chassis?
Question:
Where is the brake controller adapter on a 1996 Damon Daybreak 3150 motorhome, on a Ford F53 chassis? I have the dash panel out, and I cant locate it.
asked by: Steven S
0
Expert Reply:
I have an answer for you. Your vehicle does not have a brake controller port on that chassis. Ford started making break controller ports for the F-53 in 1999. In order to install a brake controller, I recommend hard-wiring into the wiring system of the vehicle.
expert reply by:
Bob C
0
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford, Lincoln, Mercury
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Recommended Replacement Brakes for a 2007 Pace Trailer w/ 15 Inch Rims
- Article: Brake Controller Installation: Starting from Scratch
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Q&A: Bulldog Powered-Drive Kit Compatibility With 12K Ram Landing Gear
- Q&A: Best Brake Controller for a 2014 Fleetwood Bounder Motorhome
- Q&A: Location of Brake Controller Wiring Connector on 2014 Fleetwood Bounder on Ford F-53 Chassis
- Q&A: Recommended Brake Controller for a 2022 Ford Explorer w/ Factory Towing Package
- Q&A: Replacement AC Unit for Dometic Duo-Therm Air Conditioner 630516.331 on 2008 Four Wind Siesta