Depth of BB1980T-SS Bearing Buddy Bearing Protector
Question:
Can you tell me the inside depth of this cap? Im looking to verify the distance from the grease outlet to the edge of the cap. Thanks.
asked by: Bill M
0
Expert Reply:
Before it's filled with grease, the spring loaded piston is recessed by about 5/8 of an inch inward from the outside edge of the Bearing Buddy. This distance will decrease as grease is added. The top of the zerk fitting is located 1/4 inch from the outer edge of the Bearing Buddy.
I've showed these dimensions in the provided photo.
expert reply by:
Mike L
0
Depth of Bearing Buddy BB1980T-SS Bearing Protector
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1980T-SS - Threaded - Stainless Steel (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.98 Inch
- Bearing Buddy
more information >
Continue Researching
- Q&A: Replacement Hub, Bearings, and Grease Seal for 3,500 lb Dexter Axle
- Q&A: Replacement Stainless Steel Kodiak Trailer Brake Kit For 6,000LB Axle With 6 On 5-1/2 Bolt Pattern
- Q&A: Suggested Replacements for Titan Coupler and Brake Calipers
- Q&A: Correct Replacement for Ttian 225S Disc Brake Calipers
- Q&A: Can I Use Different Grease w/ the CE Smith Trailer Idler Hub Assembly?
- Article: Most Popular Wheel Bearings
- Q&A: Battery Charger for a Trailer Battery on a Dump Trailer
- Q&A: How To Tell What Size Bearing Buddy Is Needed for My Trailer Hubs
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers