SnapPad XTRA Jack Pads Weight

Question

Question:

Can you tell me how much 6 of the 9inch Jack Pads weigh? Thanks!

asked by: Mike S

0

Expert Reply:

The six jack pads in the SnapPad XTRA Pack # SP54FR6 weigh approximately 30lbs.

expert reply by: Kevin C

0

Answer 1

SnapPads like the SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 9" Round Jack Feet - Qty 6 Item #SP54FR6 can be taken off and on as needed so you won't have to keep replacing them every time you need to take them off.

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 3

It is difficult to say without more information. It is really going to depend on the power used by the fridge and the size of your batteries. For example, a fridge like the Everchill #324-000119 uses 11-amp hours of power, so it's going to…

view full answer...

Answer 4

Hey Bryan, thanks for reaching out! Your Reese Elite Series Hitch (discontinued part 30143) has a height range of 14-1/2" - 17" and is only able to secure to the OEM puck system on your 2021 Ford F-450 Super Duty, so we either need…

view full answer...

Answer 5

There's unfortunately not a guide to tell us the sizing of your trailer's jack pads so you'll want to measure and note the shape of each pad. I've run into numerous situations where the front and rear pads were either…

view full answer...

Answer 6

The Clearsource Ultra RV Water Filter System w/ VirusGuard #CS87FR weighs 34.125 lbs.

view full answer...

Answer 7

Hey Jeff, appreciate all the details you provided that was super helpful and we do have the MORryde cushioned pin box that is designed to replace a Lippert Rhino pin box. For the 17,695 lb GVWR you mentioned on the 2024 Brinkley Model Z 3610, what…

view full answer...

Answer 8

There's not many differences between the Air Lift WirelessONE item #AL25980EZ and item #AL25980. The main difference is that the item #AL25980EZ has a slightly higher CFM at 1.03 compared to 0.92 and it runs slightly more efficient at 9% over 15%…

view full answer...

Answer 9

Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.

view full answer...

SnapPad XTRA Jack Pads Weight

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching