O.D. Dimension Of Pilot On Kodiak Disc Brake Kit K2HR35DS
Question:
Can you verify what the outer diameter of the wheel hub is so I can verify if my current wheels will work on these. My current hub OD is 2.58 Thanks
asked by: Duane O
0
Expert Reply:
I would be happy to!
The outside diameter of the pilot on the Kodiak Disc Brake Kit # K2HR35DS that would go through the center of your wheels measures 2-1/2" as shown in the included diagram.
This will still work perfectly with your wheels as it is virtually the same as your current hub based on the measurement you provided.
I included a video of the # K2HR35DS for you to take a look at.
expert reply by:
Samuel C
0
O.D. Of Pilot On Kodiak Disc Brake Kit # K2HR35DS
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet and Stainless - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 3500 lbs
- Brake Assembly
- 5 on 4-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacing Knott Brand Brake Calipers And Rotors On A Coyote Boat Trailer With 3,500 lb Axles
- Q&A: Kodiak Disc Disc Brake Kit Replacement for 2019 Coyote Dual Axle Boat Trailer
- Article: Most Popular Wheel Bearings
- Q&A: Recommended Disc Brake System for Salt Water Boat Trailer with Tandem Axles
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: What is Maxx Coat on DeeMaxx Disc Brake Kit and Why is There a Mix of That and Stainless Steel
- Q&A: Can Electric Brakes be Used on a Boat Trailer
- Q&A: Replacement Grease Seal For Kodiak Disc Brakes To Fit Spindle With 1.68"
- Article: Trailer Wiring Diagrams
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Replacement Hub/Rotor and Bearings for Tie Down Engineering TDE46245
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Install E-Track in 3 Easy Steps
- Article: Stability Control for Heavy Duty Vehicles