How Does Trailer Jack with Single Wire Wire to Trailer Wiring

Question:

Hi, I dont see the wire installation video mentioned. I want to purchase this jack but, I need to see how it would be wired to my 7 way. Thanks.

asked by: Raymond S

Expert Reply:

The Husky jack you mentioned is no longer available which why the install video is not where you are looking but for a similar jack we have the Stromberg Carlson part # SC63VR which has a 4,500 lb capacity and installs in the same way with a single wire. I attached a review video for more info on it for you to check out as well.

If you were to wire it to a 7-way you'd have to wire it to the 12 volt accessory circuit which is the pin in the 1:00 position. Most of the time these are wired to a trailer battery directly. The motor grounds through the mounting hardware of the jack so there's no need to run a separate ground wire.

expert reply by: Jameson C