Testing Power to A-Frame Trailer Jack and Recommended Replacement For Failed Motor
Question:
The power quit but the manual override works and the light works. I tried replacing the switch to no avail.
asked by: Mike B
Expert Reply:
It sounds as if the motor has failed on your tongue jack. You can verify by using a Test Light # PTW2993 on the wiring that runs to the motor. If you can confirm that you are getting power to the motor and all the wiring connections are tight then it must be a bad motor.
I recommend replacing it with a Lippert Smart Jack Electric Trailer Jack # LC643589. This jack has built in memory features as well as an auto retract feature. So you will be able to set your jack to remember your truck ball height making hooking up much faster. A battery meter on the jack will let you know if your trailer battery is getting low.
Products Referenced in This Question
Lippert Smart Jack Electric Trailer Jack w/ Footplate - A-Frame - 22-1/2" Lift - 3.5K - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 22-1/2 Inch Lift
- Bolt-On
- 1 Jack
- Lippert
more information >
Product Page this Question was Asked From
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?
- Q&A: Can the Curt Custom Tail Light Wiring Kit Be Used With LED Lights