Is Cap of Hydrastar Brake Actuator # HBA16 Vented
Question:
Is the fill cap on the actuator supposed to be vented? On the one im installing now the rubber piece under the cap gets sucked down tight against the fill neck with a lot of vacuum under it. Thanks Thanks
asked by: Jack H
0
Expert Reply:
I spoke with my contact at Hydrastar and he first said that what you are experiencing is totally normal but the cap is not vented and instead the system is vented on the side of it.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Hydrastar Electric Over Hydraulic Actuator for Disc Brakes - 1,600 psi
- Brake Actuator
- Electric-Hydraulic Brake Actuator
- 1600 psi
- Disc Brakes
- Hydrastar
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Are 1/2-20 Lug Nuts Able To Be Used On M12-1.5" Wheel Studs?
- Q&A: Replacement Studs for RVD-H-865 7k Hub/Drum
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Troubleshooting Trailer Lights Which are Not Working
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Adding Electric Over Hydraulic Disc Brakes
- Q&A: Correct Replacement Oil Seal 225255UC for Ranger Boat Trailer
- Q&A: Can Dexter E-Z Flex Suspension Kit Replace Dexter 13-10 Equalizer
- Q&A: What Size Battery Is Needed for the Lippert 6-Point Ground Control
- Q&A: Bolts and Bracket for the Tie Down Caliper to Kodiak Caliper
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer