Replacement For Marine Trailer Jack With Bent Yoke

Question:

Guy I bought a boat from didnt raise the jack. He destroyed the wheel, which I found on here, but he also bent the yoke pretty bad. Can I get a replacement yoke? If so, how do I remove the old one?

asked by: Dave E

Expert Reply:

The yoke is not available as a replacement piece, which is why the Fulton Replacement Wheel # F6811S00 is just the wheel. Some jacks have replacement casters with the wheel, but it sounds like yours does not, or it would have been easily removable by the pin. So the best option, if your yoke is bent, is going to be to replace the jack.

You can get a bolt-on jack that is a really good value from Fulton:

- Fulton Round, Snap-Ring Swivel Marine Jack # FTJ12000101

This jack will fit trailer frames that are up to 3" x 5", it has a 1,200 lb capacity which is more than enough for the vast majority of boat trailers, and offers up to 10" of lift.

I have added a link below to a video review for you to check out as well if you'd like to take a look.

expert reply by: Kyle S