Sway Control Bracket that Fits 2 inch Hitch Ball Mount
Question:
Will this work with a 2” ball with 2” and short shank? I’m ordering the reece friction bar to eliminate sway and need a plate to hook it to. I’m pulling a 4,000 lb. single axle camper with a 2004 Suburban and when I get to 60 mph on the interstate it starts to sway and if the wind is blowing I can only go 55 mph. If something else would work better please give your advice.
asked by: Anita D
1
Products Referenced in This Question
Reese Sway-Control Bracket for 2" Ball Mounts - Class III and IV
- Accessories and Parts
- Weight Distribution Hitch
- Adapters
- Sway Control Parts
- Brackets
- Reese
more information >
Product Page this Question was Asked From
Reese Sway-Control Bracket for 1-1/4" Drawbars - Class II
- Accessories and Parts
- Weight Distribution Hitch
- Adapters
- Sway Control Parts
- Brackets
- Reese
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Parts Needed to Add Brake Controller to 2024 Toyota Sienna Platinum
- Q&A: Recommended Trimax Trailer Wheel Chock and Lock for 175/80R/13 Tires
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Recommended Sway Control Option for Small Trailer
- Q&A: What is the Difference Between the Curt 17200 and Reese 83660 Friction Sway Controls?
- Q&A: Replacement Bearings and Seals Based On Printed Number On Face Of Bearing
- Q&A: Replacement Touch Screen Control Panel For Lippert 6-Point Leveling System
- Q&A: Does Replacement Touch Screen LC83VR Replace # 675806
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Which Sway Control Hitch is Right For Your Trailer?