Solution for Needing Replacement Spring for Dutton Lainson 1402A Winch

Question

Question:

I need a spring for my Fulton 1402A winch…will the replacement that you sell work?

asked by: Noah T

0

Expert Reply:

The 1402A winch is a Dutton Lainson and the only way we can help get a spring for that winch is with the part # DL70455.

expert reply by: Jameson C

0

Answer 1

I would be happy to help you get the winch cable installed on your Fulton High-Performance Brake Winch #F143201, but unfortunately there is no online install instructions for this. To get the steel cable installed you will need to pass the cable from…

view full answer...

Answer 2

I do have an option for you but the Fulton Boat Trailer Winch T1801Z1650 has been discontinued and there are no direct replacement parts available for this model. Therefore, you will have no other option but to replace the entire winch for which I…

view full answer...

Answer 3

I attached a picture that has all of the mounting hole dimensions of the Fulton winch part #F142400 that you referenced.

view full answer...

Answer 4

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 7

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 8

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 9

For all intents and purposes, yes, the Fulton drop leg stabilizer jack SJL80300 is the same as the square leg jack you asked about: - Square Drop Leg Stabilizer Jack - 18" Travel - 2,000 lbs #SJ-R208 Different manufacturers but otherwise they…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Solution for Needing Replacement Spring for Dutton Lainson 1402A Winch

Products Referenced in This Question

Continue Researching