How To Confirm Fit of Standard Trailer Light Kit with 25' Wire Harness
Question:
Will the part # TL29BK trailer rear light kit replace the rear tail lights on the DIY Trailer KIT LCI 851T? It has to be at least 15 years old, 134 inches long with a 4 by 8 frame.
asked by: Ed D
0
Expert Reply:
The Standard Trailer Light Kit with 25' Wire Harness part # TL29BK is a universal fit trailer wiring harness. It is designed for trailers under 80" wide. The tail lights use a petty standard two stud mount. The kit also comes with a harness, marker lights, and plate holder.
I cannot confirm fit on any one specific make/model unfortunately.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Standard Trailer Light Kit with 25' Wire Harness
- Trailer Lights
- Tail Lights
- License Plate
- Rear Reflector
- Side Marker
- Side Reflector
- Stop/Turn/Tail
- Square
- Kit
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 5L x 4-1/2W Inch
- Red and Amber
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Most Popular Wheel Bearings
- Q&A: The Function of the Auxiliary 12-Volt Connection on the 7-Way Trailer Connection
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: ST205/75/15 Spare Wheel And Tire Combo For A 1974 Pull Behind Camper
- Q&A: Ways to Install New 4-Pole Trailer Connector
- Q&A: Recommended Tire and Wheel for an Old Coleman Columbia Pop Up Camper
- Q&A: Replacement 4.80-8 Tires for a 1984 Coleman Pop Up Camper Trailer
- Q&A: Recommended Wheel/Tire Combo for 1991 Coleman Newport Pop-Up Camper
- Q&A: How to Rewire an Old Cattle Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)