Distance From Center of Lug to Channel On Lock N Roll Articulating Channel Tongue Trailer Coupler
Question:
what is the length of the trailer side from the hitch pins to the tongue mount for the 508 weld on for 3inch tongue thanks
asked by: Ken
0
Expert Reply:
The distance from the center of the lug to the base of the channel plate on the Lock N Roll Articulating Channel Tongue Trailer Coupler part # 336TS508 is 4-3/4".
expert reply by:
Conner L
0
Product Page this Question was Asked From
Lock N Roll Articulating Channel Tongue Trailer Coupler - 3" Channel - Trailer Side
- Straight Tongue Trailer Coupler
- Off Road Coupler
- Bolt-On
- Weld-On
- 11000 lbs GTW
- 3 Inch Channel
- Latch Plates
- Lock N Roll
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Article: How to Store a Travel Trailer/Camper for the Winter
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Protective Case for NOCO Boost X Jump Starter
- Q&A: Recommended Replacement For A Dometic Duo-Therm Rooftop Unit
- Q&A: Recommended Replacement For A Dometic DOTR12CB RV Microwave
- Article: The Differences Between Cam Buckles and Ratchet Straps (And Who Would Win In a Fight)
- Q&A: Do You Cut Tabs on Both Stacked SeeLevel Sensors SE88VR
- Q&A: Is There A Swing-Away Hitch Adapter That Can Haul E-Bikes And A Boat
- Q&A: Replacement Hub for a UFP H-1377 on a 2004 Tahoe Boat Trailer
- Q&A: Availability Of 33" Ark Stabilizer Jack And Dimensional Diagrams Of Similar Ark Corner Steadies
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams