Picking Out Landing Gear for 2004 Crossroad Cruiser
Question:
What landing gear would fit my 2004 crossroad cruiser 5th wheel?
asked by: Robbie B
Expert Reply:
The easiest way to pick out replacement landing gear sets is to go by the distance between the brackets either on the trailer or on the legs themselves so that you can pick out a set that will match up to the trailer without needing modifications.
Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Bulldog Tandem Landing Gear Set # BD500162. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and then install the brackets of the # BD500162.
I attached a picture that shows the dimensions that this landing gear set would fit with.
The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) is 17-1/2 inches. If this is the case, the landing gear should fit just fine.
If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement.
Products Referenced in This Question
Bulldog Tandem Landing Gear Set - Drop Leg - 36" Lift - 8,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 7001 - 8000 lbs
- Landing Gear
- Sidewind Jack
- 36 Inch Lift
- Bolt-On
- 2 Jacks
- Bulldog
more information >
Product Page this Question was Asked From
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Best Landing Gear Upgrade Options for 5th Wheel Trailer
- Q&A: Atwood 87701 landing gear switch replacement
- Article: Trailer Wiring Diagrams
- Q&A: Landing Gear Skips and Legs Wont Extend When Raising Trailer Jack
- Q&A: 5th Wheel Landing Gear Motor Makes Loud Clicking Noise and Will Not Raise Trailer
- Q&A: Availability Of 33" Ark Stabilizer Jack And Dimensional Diagrams Of Similar Ark Corner Steadies
- Q&A: Overall Length of the 24" and 30" Ark Drop Down Corner Stabilizer Jacks
- Q&A: Solution for Replacement Leg for Discontinued Atwood Levelegs
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How Much Solar Power Do I Need For My RV?
- Article: Does Solar Panel Type Really Matter?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps