Is the Reese POD Brake Controller Supposed to Light Up with Brakes Applied and No Trailer Attached
Question:
Does light on Reese POD controller supposed to come on when brake applied when no trailer hooked up?
asked by: Kyle
0
Expert Reply:
I spoke with Reese about your POD controller.
When you apply the brakes with no trailer hooked up, the light will flash red briefly. It should turn off shortly.
However, if it stays on, then there may be a problem with the blue wire. Trace this wire to look for frays or corrosion. If you see any, you will need to replace it. Problems with this wire will "trick" the controller into believing that there is a trailer hooked up.
You might also test your 7-way with a circuit tester like part # PTW2993 to make sure everything is working properly there.
expert reply by:
Kef G
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Parts Needed to Flat Tow 2023 Jeep Gladiator
- Article: Determining Trailer Tongue Weight