Recommended Pad To Add To Trailer Fenders for Stepping
Question:
Hi. I have a trailer with metal fenders measuring 40inch long and 8inch wide. I occasionally end up stepping on the fenders to secure loads. The fenders are painted and very slick. Do you offer any pad preferably adhesive that is close to the measurements listed above. Thanks for your help.
asked by: Greg P
Expert Reply:
The Valterra Non-Skid Grip Tape part # A10-2210VP would be an excellent option to add to a steel fender for extra grip. It won't cover the entire fender but you can still run a few strips along the top which will provide plenty of grip. If you're looking for something with a bit taller profile then I recommend the TowSmart SmartStep Non-Slip Pad part # 348780. I don't think there would be one single pad to cover the entire fender but this would not exactly be needed to provide grip for stepping.
Products Referenced in This Question
Valterra Non-Skid Grip Tape - 10' Long x 2" Wide - Black
- Accessories and Parts
- RV Steps
- Grip Tape
- 2 Inch Wide
- 10 Feet Long
- Valterra
more information >
Product Page this Question was Asked From
TowSmart SmartStep Non-Slip Pad - Rubber w/ Adhesive Backing - 17-1/2" Long x 4" Wide
- Accessories and Parts
- Bumper
- Nerf Bars - Running Boards
- Step Pad
- TowSmart
more information >
Continue Researching
- Q&A: Replacement Microwave for my High Pointe EC942K9E in Stainless
- Q&A: Recommended Replacement For An Atwood GCH6A-10 E S RV Water Heater
- Q&A: Correct Pull Out Steps For 25.5" Mounting Bracket Width
- Q&A: Recommended Weather Resistant Non-Slip Rubber Pad For RV Steps, Bumpers, And Ladder Rungs
- Q&A: 3 Step RV Step Replacement Solution for Brackets 25-1/2 inches in Width
- Q&A: Suitability of Draw-Tite Class I Receiver Part # 24631 for 1998 Jeep Wrangler with C Channel Bumper
- Q&A: Hardware Kit for Roadmaster EZ5 Base Plates on 2017 Jeep Wrangler
- Article: Performance Chips and Modules