Trouble Shooting Hydraulic Slide Room Pump Stopped Moving Slide In And Out.

Question:

I have a LC141111pump on a single slide. It was going out fine but had trouble coming in. It would come in then bog out to a stop, it would go back out slowly to full extension. Brought it in about a foot and now nothing. No in or out, stuck. Checked voltage 12v good., Ground good. Solenoid good. Tried Manual Retract with 1/4inch drive and drill, no response in or out. disconnected slave cylinder, ran pump in both directions no fluid in or out. Faulty pump or Check valve? What would you suggest?

asked by: William T

Expert Reply:

It sounds like the pump went out. You could just try replacing the pump motor Item # LC167576, if you think your reservoir is still good. Or you can just replace the whole thing with Item # LC141111, so you know it's all new.

expert reply by: Shane H