How Does Lippert Ground Control go Into Manual Mode
Question:
How do I put it manual to reset the system?
asked by: Jim
Expert Reply:
To put your Lippert Ground Control into manual mode it's really just a matter of pressing the manual button on the control panel that's on the top left side of the control panel.
Zero Point Calibration
The “Zero Point” is the programmed point that the trailer will return
to each time the Auto Level feature is used.
Note: Prior to starting this procedure, double check all connections
on the controller, jacks, and touch pad.
1. In manual mode, run the jacks to level the trailer. This is best
achieved by placing a level in the center of the trailer and leveling
it both front to back and then side to side. (See “Basic Jack
Operation” for instructions on how to manually operate the system).
2. Once the trailer is level, turn off the touch pad.
3. With the touch pad off, press and release the “FRONT” button five (5) times and then press and release the “REAR” button five (5) times.
4. The touch pad will flash and beep and the display will read “ZERO
POINT CALIBRATION ENTER to set, Power to Exit”.
5. To set the current position as the zero point, press the “ENTER”
button.
6. LCD display will read “Zero point stability check”.
7. LCD display will read “Zero point set successfully” once process is
complete.
8. The system will set this point as its level state and the touch pad
will turn off.
Product Page this Question was Asked From
Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Control Kit
- Lippert
more information >
Continue Researching
- Shop: Americana Trailer Wheel Center Cap - Stainless Steel - 4.88" to 4.90" Pilot
- Shop: Lionshead Trailer Wheel Center Cap w/ Snap-In Plug - 4.88" to 4.9" Pilot - Stainless
- Shop: Replacement Rear Wheel Holder Assembly for Thule T2 Pro Platform Bike Racks - Qty 1
- Q&A: How To Operate Middle Jacks Of A Lippert Ground Control 3.0 Leveling System
- Shop: Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System
- Shop: 6-Leaf Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long
- Shop: Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System
- Shop: Hydraulic Jack Adapter Lugs for JT's Strong Arm Jack Stabilizer Kits - Qty 2
- Q&A: Troubleshooting Flashing Display of Lippert Ground Control and Jacks Won't Retract
- Video: Lippert Ground Control Leveling System Control Panel Review
- Q&A: How To Clear Lippert Ground Control Leveling System Error
- Q&A: Left Side Jack on Ground Control 3.0 Is Not Responding
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Q&A: How to Clear Retract Time Out Return Levelers Error on LCI Level Up System
- Q&A: Correct Replacement Control Module for Lippert Ground Control 3.0 4-Point System
- Video: Fogatti RV Tankless Water Heater Installation - 2007 Starcraft Homestead Lite Fifth Wheel
- Video: Review of Lippert Components Trailer Camper Jack - Replacement Control Unit - LC421484
- Shop: Brake Controller
- Video: Lippert Ground Control Leveling System Control Panel Installation - 2019 Grand Design Reflection Fif
- Video: Lippert Ground Control Electric RV Leveling System Manufacturer Demo
- Video: Review of Lippert Components - Trailer Jack,Camper Jack - LC242623
- Shop: Fifth Wheel Hitch
- Video: Curt Fifth Wheel - Fixed Fifth Wheel - C16130 Review
- Search Results: lippert 234802
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Roadmaster Vehicle Specific Base Plates
- Shop: Base Plate for Tow Bar
- Search Results: base plates
- Search Results: generator sliding tray