What are the Front to Back and Side to Side Dimensions of Curt Bumper Hitch E-3S
Question:
what is the total length of the 2inch reciever on this hitch and how far is the lich pin hole from the the face of the reciever?
asked by: Wolfgang L
0
Expert Reply:
On the Curt bumper hitch # E-3S the face of the receiver is approximately 2 inches out from the nearest part of the flat plate. The hitch pin hold is slightly back from that, the center being about 5/16 of an inch further back than the plate.
The overall width is 14 inches. The flat part on top is 11 inches side to side. I have included a link to the installation instructions for you to view.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt 2" Trailer Hitch - Bumper Mount - 8-3/4" Bolt Pattern - 5,000 lbs GTW
- Bumper Hitch
- 500 lbs TW
- 5000 lbs GTW
- 2 Inch Hitch
- Bolt-On
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Recommendation For Increasing Strength of Rear Bumper Attached to Spacers Off Of Trailer Frame
- Q&A: Trailer Hitch Receiver Options For A Box Trailer Frame
- Q&A: Recommended Roof Rack for a Interstate 7X16 Cargo Trailer
- Q&A: Replacement Trailer Tires Size 7.50-16LT Load Range F
- Q&A: Trailer Hitch Receiver Fit For 2024 Nissan Pathfinder
- Q&A: How Tall is the Exterior Portion of the Ventline Vanair 12-Volt Trailer Roof Vent # VP-543SP
- Article: My Trailer Hitch Doesn't Fit
- Article: Best Hitches for Travel Trailers (2022) - For a Smooth, Sway-Free Ride
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller Installation: Starting from Scratch
- Article: Types of Bumpers
- Article: Which Hitches are Made in the USA