Installation Recommendation for Trailer D-Ring Tie Down # RR05 in a Trailer Securing 1k lb Trencher
Question:
I have a 7 x 14 enclosed trailer with 3/4 inch plywood floor do i need to weld these d rings to frame or will the backing plate be good enough. i am tieing down 1000lb trencher machine
asked by: Kevin
0
Expert Reply:
Considering the weight of your trencher machine I would recommend you secure the Trailer D-Ring Tie Down # RR05 to the frame of your trailer. You could do this by securing the backing plate # BP05 to your frame and then attaching the # RR05 to it.
I would recommend you have a qualified welder attach the # BP05 to your trailer frame.
expert reply by:
Jameson C
0
Products Referenced in This Question
Backing Plate for Brophy Recessed D-Ring Tie-Down Anchor
- Accessories and Parts
- Tie Down Anchors
- D-Ring Backing Plates
- Brophy
more information >
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 4-7/8" Wide - Recessed Mount - 1,600 lbs
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Tie-Down Cleats and Rings
- 1600 lbs
- D-Ring
- Recessed Mount
- Brophy
more information >
Continue Researching
- Q&A: Solution for Atwood Surge Brake Coupler Needing Replacement Parts
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Replacement Key Needed for Gorilla Guard Trailer Coupler Lock
- Article: Big Truck Big RV
- Q&A: Factory Brake Wiring Harness Location on 2012 Chevy Silverado
- Q&A: Are There Any Trailer Hitch Fits for a 2023 Ford Escape Plug-In Hybrid
- Article: Pintle-Hitches
- Q&A: How to Determine the Correct Replacement Bearings for a Trailer
- Q&A: Can You Replace A GE Air Conditioner Be Replaced With An Advent A/C?
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Tire Sizing
- Article: How to Install E-Track in 3 Easy Steps