Tandem Axle Hanger Kit for 2-1/2 inch Wide Slipper Spring with 48-1/2 inch Axle Spacing
Question:
I have a Brooks Brothers Trailer with a AL-KO Hayes suspension. After taking measurements, I have found the replacement equalizers would be the 09138710 and 09138711, but I cannot find replacement hangers for front, center and rear that are the same measurements as what is on the trailer. Any suggestions for this since AL-KO was bought out by Dexter? Do you have a hanger kit that would fit with those equalizers? The axle spacing is 48 1/2. We are willing to change it all over to Dexter parts, just not sure which kit would be best.
asked by: Staci L
Helpful Expert Reply:
Since you have a 2-1/2 inch wide slipper spring setup and the axle spacing is 48-1/2 inches the easiest solution for a tandem axle hanger kit would be the part # HAP-158-258-03 which matches all of that perfectly. This does use a different equalizer than what you mentioned but would work great still.
Products Referenced in This Question
Dexter Tandem-Axle Trailer Hanger Kit for 2-1/2" Slipper Springs - 48-1/2" Axle Spacing
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2-1/2 Inch
- Tandem Axle
- Redline
more information >
Product Page this Question was Asked From
Dexter Tandem-Axle Trailer Hanger Kit for 2-1/2" Slipper Springs - 48-1/2" Axle Spacing
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2-1/2 Inch
- Tandem Axle
- Redline
more information >
Continue Researching
- Shop: Trailer Hitch
- Shop: TorkLift SuperHitch Original Trailer Hitch Receiver - Custom Fit - Class V - Dual 2" Receivers
- Shop: U-Bolt Plate - 3" Diameter, Round Trailer Axle - 1-3/4" Wide Spring - 1/2" Bolts
- Shop: Dexter Tandem-Axle Trailer Hanger Kit for 2-1/2" Slipper Springs - 48-1/2" Axle Spacing
- Shop: Dexter Tandem-Axle Trailer Equalizer Kit for 2-1/2" Slipper Springs - 24-5/8" Equalizers
- Shop: Dexter 5-Leaf Slipper Spring w/ Flat End for 10,000-lb Trailer Axles - 30-1/2" Long
- Shop: Dexter 5-Leaf Slipper Spring w/ Flat End for 10,000-lb Trailer Axles - 30-1/2" Long
- Q&A: How to Determine if Dexter Tandem-Axle Trailer Hanger Kit for 2-1/2 Slipper Springs Will Work
- Shop: Hayes Spring Eye Bushing for 10k Springs
- Shop: Ladder Rack
- Search Results: 13~141~3
- Search Results: 13" equalizer
- Search Results: swan
- Search Results: ap216
- Q&A: Axle Placement and Suspension System for 20,000 lb Bumper Pull Trailer
- Q&A: Hanger Kit For Tandem Axle Trailer With 2-1/2 Inch Slipper Springs & 10,000 lb Axles
- Search Results: spring bushing
- Search Results: tire
- Search Results: 20565r10
- Q&A: Lug Nut Torque for Aluminum Trailer Wheels
- Q&A: Determining Proper Axle Spacing
- Article: Where to Position the Trailer Axle?
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Q&A: Troubleshooting 2017 Toyota Tacoma Sending Power Only to Trailer Right Side Tail Lights
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Article: Slipper Spring Trailer Suspension System Review
- Article: Gooseneck Trailer Hitch Information and Review
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide