How Does Yates Keel Pad YR1203SY Mount to the Trailer Crossmember
Question:
How does it attach to the traier crossmember? Do I need to order any additional hardware?
asked by: Tawn T
0
Expert Reply:
It is a bit difficult to see in the picture, but there are mounting holes in the 4 tabs along the sides of the # YR1203SY keel pad. You would just need to screw through the tabs to the sides of the cross member. We do not offer any hardware specifically for this pad, but you should have no trouble obtaining some screws locally.
View a video review at the included link. I also made a diagram showing the tabs to which I am referring.
expert reply by:
Sarah L
0
Product Page this Question was Asked From
Yates Keel Pad - TPR - 11-3/4" Long x 3-1/2" Wide
- Boat Trailer Parts
- Guards and Pads
- Keel Pad
- 3-1/2 Inch Wide
- 11-3/4 Inch Long
- Yates Rubber
more information >
Continue Researching
- Q&A: Does Adapter Module for BrakeRite Electric Over Hydraulic Actuator Install on Trailer or Vehicle
- Q&A: Will HBA-CAM Adapter Work with Brake Controllers that Don't Require the Adapter
- Q&A: Adapter Module for Brake-Rite Electric over Hydraulic Trailer Brake Actuator
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Q&A: How to Install the Yates Keel Pads on Your Trailer
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Raise Your Travel Trailer Height
- Q&A: Which Tow Bar is Better Blue Ox Avail # BX7420 or Roadmaster Nighthawk # RM-676
- Q&A: ST205/75r14 Trailer Tire Vs. a ST205/75D14
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: How To Pick Out Correct Replacement Seal
- Article: How to Accurately Measure Trailer Leaf Springs