Is the Pre-Cut Fender Back for Redline Trailer Fender F9X32-1R Painted
Question:
My fender bunks are black. Is this one black? It looks gray on website.
asked by: Jason A
0
Expert Reply:
The Pre-Cut Fender Back for Redline Trailer Fender F9X32-1R part # 12FB-32R is unfinished. Therefore, you'd need to paint/coat it prior to use.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Pre-Cut Fender Back for Redline Trailer Fender F9X32-1R - 12" Wide
- Accessories and Parts
- Trailer Fenders
- Fender Back
- 12 Inch Wide
- 30 Inch Long
- Redline
more information >
Continue Researching
- Q&A: How to Determine Hub and Spindle Size
- Q&A: Backing Plates for Trailer Fenders
- Q&A: How To Determine The Correct Hub/Drum Assembly Based on Spindle Size
- Q&A: Will The Blue Ox Patriot Activate Like A Breakaway Event IF The Towed Vehicle's Battery Dies
- Q&A: What is Difference Between Timbren Axle Less Kits TASR7KS01 and TASR7KS02
- Q&A: How to Determine Replacement Trailer Wheel Bearing Sizes
- Q&A: Fuse Location for 12-Volt Accessory Feed to 7-Way Trailer Connector on 2005 Chevy Silverado
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Trailer Tire Sizing
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Install E-Track in 3 Easy Steps
- Article: Printable Trailer Bolt Hole Pattern Template