Which A-Frame, Top Wind Trailer Jack is Shortest from Mounting Bracket to Top of Jack
Question:
what is your shortest a-frame, top crank trailer jack to keep the tailggait from hitting the jack? thanks
asked by: David M
0
Expert Reply:
The A-frame, top wind jack that has the shortest distance is going to be the Bulldog jack you referenced, # BD155032. From the mounting bracket to the top is a little over 10 inches (10.2).
Another possible solution is to use a longer ball mount to move the trailer further back so the tail gate can lower without hitting the jack. We have some very long ball mounts, see link, some of which have a distance of 16 inches from the center of the hitch pin hole to the center of the ball hole.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Bulldog Round, A-Frame Jack - Topwind - 15" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Topwind Jack
- 15 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Bulldog
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Looking for Shorter A-Frame Jack to Clear my Tailgate
- Q&A: Recommended 5,000lb Topwind Trailer Jack Replacement
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Q&A: Can't Lower Truck Tailgate Because it Hits the Trailer Jack
- Article: Trailer Wiring Diagrams
- Q&A: Placement and Number of Safety Chain Mounts Needed on Trailer
- Article: My Trailer Hitch Doesn't Fit
- Article: Best Hitch Cargo Carriers
- Q&A: Replacement Cover for Trailer Roof Vent AS-13 M-VD0449
- Article: Best Camper Jacks
- Q&A: Low Profile Trailer Jack Recommendation for Better Tailgate Clearance
- Q&A: Replacement Jack Options For a 2012 Casita Spirit Deluxe
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Tire Sizing