bing tracking image
Q & A Icon

Tow Bar Wiring Parts Needed for Flat Towing on 2014 Ram 1500 with Brake Buddy Supplemental Braking  

Question:

I have a 4 pin flat connector from my motorhome to my Ram 1500 to operate the RV turn, stop, and parking lights on the truck when towing the truck. I also have a brake buddy that has a charging pin that is supposed to connect to a hot wire from the motorhome. What is the easiest way to make that connection? Obviously the 4 pin doesnt have a hot wire.

0

Expert Reply:

The best solution for this is going to be installing a 7 way with a fully operational charge line using something like the Hopkins Endurance Quick-Install 7-Way Trailer Connector with Universal Pigtail Harness - Vehicle End # HM47210. You'll be able to use the existing wiring just by cutting off the plug on the 4 way and splicing into the Hopkins harness; then you'll just need to run a line to the battery and for a brake controller if you're using one.

Once you've got a fully operational 7 way you'll be able to use a new tow bar wiring setup like the Roadmaster # RM-15267, which comes with diodes to protect the electrical system. This will give you the wiring to plug into the 7 way you're installing on the RV.

I've linked a short review video of this part for you to check out.

expert reply by:
0
Erik B

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>