Can the CargoSmart Board Holder Be Adjusted Without Removing the Boards
Question:
So to make this fully adjustable using 2x4s it looks like you have to cut the wood short so that you can access the small tab located at the back of the bracket??
asked by: Steven G
Expert Reply:
In regards to the CargoSmart Board Holder part # 348892, you'll need to remove the board completely to adjust the brackets. The brackets need to come out away from the track in order to change positions. It's not required that you screw the boards to the bracket. If you were going to frequently adjust the brackets then I would not use screws.
I suppose it is possibly to try and cut the boards shorter to adjust the brackets without removing the boards but I really don't have much advice on this unfortunately as it's not something we've tried.
Product Page this Question was Asked From
CargoSmart Board Holder for E Track and X Track Systems
- E-Track
- E-Track Cargo Organizers
- Board Holder
- CargoSmart
more information >
Continue Researching
- Q&A: Is E-track Stronger Than X-track, Is There An Advantage Of One Over The Other
- Q&A: Shelving Options That Mount to Trailer Wall
- Article: Pintle-Hitches
- Q&A: Using E-Track to Make Bunk Beds Inside of an Enclosed Trailer
- Article: Cargo Tie-Down Methods
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Dual Propane LP Tank Setup 100 Lb for RV or Travel Trailer
- Q&A: What Is The Maximum Intermittent Amp Rating For The Bulldog Winch 500 Amp Shut-Off Switch
- Q&A: Why Doesn't CargoSmart Rotating Board Holder for E-Track and X-Track System Have Weight Capacity
- Q&A: Tips for Installing E-Track on a Trailer with Tube Aluminum Frame
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision