Replacement Handle or Handle Grip for a Fulton Pro Series PSEJ10000101 Trailer Jack
Question:
I need the plastic handle that bolts on the crank handle, you crank it up and down with this plastic handle, you put your hand on this to crank it.
asked by: Wilbert Z
Expert Reply:
I spoke with my contact at Fulton and Pro Series and got some information for you. A lot depends on the age of the jack. If the handle is held in place by an e-clip and not a pin then there are no replacement parts available.
If the handle is held in with a pin in the top gear then you would need to replace the entire handle assembly using # F0933301S00 which is a different handle design but would fit. The black handle grip on your jack is not available as a separate part.
Products Referenced in This Question
Replacement Sidewind Handle Kit for Fulton XP10 Series Marine Jacks - 800 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- Fulton
more information >
Product Page this Question was Asked From
Pro Series Snap-Ring Swivel Marine Jack - Bolt On - Sidewind - 10" Lift - 1,000 lbs
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 0 - 1000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Bolt-On
- With Wheel
- Pro Series
more information >
Continue Researching
- Q&A: Recommended Spare Tire for a Ironton Trailer
- Q&A: Appropriate Wire Gauge For Trailer Wiring
- Q&A: Can 4.80-12 Tires Be Upgraded to 5.30-12 Tires
- Q&A: Replacement Tire Options For a 165SR13 Trailer Tire
- Article: How (and Where) to Connect an RV Propane Grill
- Q&A: How to Extend Trailer Tongue By 36 Inches
- Q&A: Faster Trailer Tire Recommendation for a 4.80-12 Trailer Tire
- Q&A: Can a 145R12 Tire Replace a 4.80x12 Bias Trailer Tire Size
- Article: Best Boat Trailer Jacks
- Article: Trailer Wiring Diagrams