Installing 7-Way to Brake Light Switch on 2018 Hyundai Santa Fe

Question:

Item # ETBC7 My car needs to run the brake switch wire back to the four pin connector because my brake wires are difficult to connect inside the cab. Is there a wire system that has that wire in it? Thanks, Jim

asked by: James J

Expert Reply:

You're correct that splicing into the brake light switch on your 2018 Hyundai Santa Fe is very difficult because of where it's located up underneath the dash. If you take a look at the video I've linked from when we installed the Prodigy P3, part # 90195, along with our # ETBC7 kit on a 2017 Santa Fe we tapped into the brake light from the factory 4-way.

In the video skip ahead to about the 9:05 mark and you'll see the panel at the rear we get under to find the correct wire. This should help you get a brake controller installed on your Santa Fe.

expert reply by: Charles S