Replacement Jack for 2014 Legend Enclosed Trailer with A-Frame
Question:
I have a 2014 Legend Enclosed trailer that I need a jack for. Do you carry anything for this trailer? Looks like it has 3 bolts that bolts through a plate on the tongue. Its not a side mount
asked by: Larry R
Expert Reply:
It sounds like you likely have an A-Frame trailer, so you can use something like the etrailer Round, A-Frame Jack - Sidewind - 15" Lift - 5,000 lbs # TJA-5000S-B which will attach to the 3 mounting points on the trailer tongue and provide you with a jack with 15" of lift. This jack doesn't come with a foot so you'll also need the Footplate for 2,000-lb and 5,000-lb Round, A-Frame Jacks # JF-99, which is designed for that jack.
If you're looking for an electric jack then something like the Ultra-Fab Electric A-Frame Jack w/ 7-Way Plug - 18" Lift - 3,500 lbs # UF38-944037 is a great choice. This is designed for A-Frame trailers and will install the same way, but it's got a bit more lift travel and is designed for trailers with tongue weights of 3500-lbs or lower. I really like that this connects directly to your vehicle's 7 way connector for power so it doesn't require any wiring into the trailer at all.
I've linked some review videos of these two jacks for you to check out.
Products Referenced in This Question
Footplate for 2,000-lb and 5,000-lb Round, A-Frame Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- etrailer
more information >
Ultra-Fab Electric A-Frame Jack w/ 7-Way Plug - 18" Lift - 3,500 lbs
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- 16 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- etrailer
more information >
Continue Researching
- Q&A: Should Butt Connectors On a Boat Trailer be Replaced with Heat Shrink and Solder
- Q&A: Comparing Optronics Aero Pro and Glolight Trailer Tail Lights
- Video: Optronics Trailer Lights A70GB Review
- Video: Review of Peterson - Trailer Lights - B421-18
- Video: Optronics Trailer Lights - Tail Lights - STL111RB Review
- Video: Review of Peterson Trailer Lights - License Plate Lights - M298C
- Video: Peterson Trailer Lights - Reflectors - B489R Review
- Video: Optronics Trailer Light Right Angle 2-Wire Pigtail Review
- Video: Optronics Trailer Lights - Clearance Lights - MCL111AKPG Review
- Shop: Peterson Great White LED License Plate Light - 4 Diodes - Chrome Housing - Round - Clear Lens
- Shop: 2" Round Grommet - Flush Mount - Open Back
- Shop: PVC Grommet for 6-1/2" Oval Trailer Tail Lights
- Shop: PVC Grommet for Peterson 6-1/2" Long Oval Trailer Lights - Flush Mount
- Shop: GloLight LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 22 Diodes - Oval - Red Lens
- Shop: GloLight LED Trailer Clearance or Side Marker Light - Submersible - 6 Diodes - Round - Red Lens
- Shop: GloLight LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 22 Diodes - Oval - Red Lens
- Search Results: 3500 torsion axle
- Search Results: trailer reflectors
- Search Results: a45pmb
- Search Results: mcl110akb
- Search Results: a45pb
- Search Results: 3 wire pigtail
- Search Results: 2 wire pigtail
- Q&A: Installing New Trailer Light with 2 Wires in Place of Trailer Light with 1 Wire
- Q&A: Replacement for Lippert 3,500 Lb LCI35-SB-85-68.5 Axle
- Q&A: Replacement Swing Down Stabilizer For 18' Aluma Trailer
- Q&A: Potential Grounding Issue When Installing Peterson License Plate Light # PM436B
- Q&A: How To Install LED Trailer License-Plate Light LPL55CB
- Shop: Brake Controller