Solution to Add Trailer Hitch to 1970 Ford Bronco
Question:
Do you sell a rear 2 receiver trailer hitch to fit an early Ford Bronco 1970? Note, the 1966 to 1977 model years are all the same. Thank you
asked by: John R
Helpful Expert Reply:
I may have a solution for you, but I did some checking with our vendors and there is not a custom fit trailer hitch for your 1970 Ford Bronco. However, you may be able to make something like the Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver - Weld On - Class V - 2" # 41990-07 work for you with some light fabrication. This is a weld on hitch for frames up to 44 inches wide that provides you with a 2" receiver tube to be used for either towing or accessories, and would be the best available solution since there is no custom fit hitch.
Product Page this Question was Asked From
Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver - Weld On - Class V - 2"
- Heavy Duty Receiver Hitch
- Weld-On
- 44 Inch Wide
- 1600 lbs TW
- 16000 lbs GTW
- Class V
- 2 Inch Hitch
- 7 Inch Drop
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Class V Hitch For A 2020 Ford F53 Chassis
- Q&A: Universal Hitch to Install on a Class A RV Rated for 10,000 Pounds
- Q&A: Trailer Hitch for 2010 IC Bus CE-Series
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Trailer Hitch For 2014 GMC Savana Cutaway Chassis
- Q&A: Recommended 10K Trailer Hitch for Ford F-53 Chassis
- Q&A: How Far Out Will Curt 15400 Extend on 2023 Ram 3500 Cab and Chassis
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: Carrying Bikes While Towing a 5th Wheel Camper Trailer
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)