Option to Make 7-Way Extension for Truck Installing Tommy Gate
Question:
We just installed a Tommy Gate on my 2021 Ford F350. The factory trailer hitch wiring connector has to be moved and the wires are not long enough. Do you make an extension cord to plug into the factory wire harness and then plug into the factory trailer wire outlet to act as an extension cord?
asked by: Ken A
0
Expert Reply:
Best option we have would be to use the part # PK11998 as a 4 foot extension like you need. You'll have to cut off the round connector you have now behind the 7-way socket and wire this in place of it as we don't have a solution that plugs right in.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
4' Pigtail Wiring Harness for Pollak Replacement 7-Pole RV Socket
- Accessories and Parts
- Trailer Wiring
- Vehicle Wiring Harness
- Universal
- 7 Blade
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Availability of Trailer Hitch and Wiring for 2020 Ford Transit T350 With Extended High Roof
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: How Does the Hopkins 7-Way part # HM40975 Wire to a Vehicle
- Q&A: Brake Switch Signal Without Tapping into Factory Wiring On 2021 Toyota Highlander For Brake Control
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller Installation on a Ford Super Duty Truck (2005-2007)
- Article: Most Popular Wheel Bearings
- Q&A: How to Add a 7-Way Connector and Brake Controller to a 2015 Audi Q7
- Q&A: Install Harness for Curt Venturer Next in 2007 Ford F-250
- Q&A: Solution for Freightliner to Tow Trailer with 7-Way Blade Connector
- Q&A: Wiring Harness to Plug into the Back of a Pollak 7-Way Trailer Connector PA66GF30
- Article: How to Measure for Trailer Hitch Drop