Availability of Longer 7-Way Harness for Chevy Silverado for Aftermarket Bumper
Question:
2020 Silverado 5500 I have installed an after market rear bumper and have mounted the OEM trailer connector to the bumper. I would like to extend the OEM harness 12 inches to fit. Do you have an OEM connector, with wires that will plug into the OEM trailer connector?
asked by: Jim C
0
Expert Reply:
We don't have anything that would fit directly but you could use the part # PK11998 which you could cut down to 12 inches and wire to the harness that's there currently.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
4' Pigtail Wiring Harness for Pollak Replacement 7-Pole RV Socket
- Accessories and Parts
- Trailer Wiring
- Vehicle Wiring Harness
- Universal
- 7 Blade
- Pollak
more information >
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Q&A: How Does the Hopkins 7-Way part # HM40975 Wire to a Vehicle
- Q&A: Brake Switch Signal Without Tapping into Factory Wiring On 2021 Toyota Highlander For Brake Control
- Article: Most Popular Wheel Bearings
- Q&A: Suspension Enhancement Options for 2021 Salem FSX 178BHSKX With Single Underslung Axle
- Article: Brake Controller Installation on a Ford Super Duty Truck (2005-2007)
- Q&A: Install Instructions for an Over Under Kit on a Camper Trailer
- Article: How to Raise Your Travel Trailer Height
- Article: Can You Flat Tow a Ford Escape?
- Q&A: How to Wire Deka # DW08771 Battery Isolator
- Q&A: How to Add a 7-Way Connector and Brake Controller to a 2015 Audi Q7
- Q&A: Install Harness for Curt Venturer Next in 2007 Ford F-250