Does the Bulldog Cast Head Trailer Coupler BD4420000317 Come with Mounting Hardware
Question:
Does the coupler come with bolts for mounting? If not, what do you recommend?
asked by: Quintin
0
Expert Reply:
For the Bulldog trailer coupler # BD4420000317 you will need to use your own hardware. The bolt holes on the coupler are 5/8 inches in diameter. You will want to use grade 5 or higher quality bolts.
The coupler could be welded on, however because this is a cast coupler and welding cast is difficult, it would have to be done by a qualified professional welder with experience in cast welding along with special electrodes to complete a weld installation.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Bulldog Cast Head Coupler w/ Wedge Latch - 2-5/16" Ball - Flat Plate Mount - 20,000 lbs
- Flat Mount Trailer Coupler
- Fixed Coupler
- Bolt-On
- Weld-On
- 20000 lbs GTW
- 2-5/16 Inch Ball Coupler
- Trigger Latch
- Bulldog
more information >
Continue Researching
- Q&A: What are the Bolt Hole Sizes on the Bulldog Cast Head Coupler and Can it be Welded
- Q&A: Can the Gen-Y Hitch 5th Wheel to Gooseneck Pin Box Be Used in a Short Bed Ram 3500
- Q&A: How to Cut a Grommet Hole for Installation of the Oval Trailer Tail Lights # STL22RB
- Q&A: What Coupler Lock Fits the Demco Trailer Coupler # DM99VR?
- Q&A: Needing a Repair Kit for a Bulldog Trailer Coupler
- Q&A: Is 76" Spring-Center Measurement Abnormal for 95" Wide Trailer Axle
- Q&A: Replacement Leaf Springs for 1998 Coachmen Catalina 364 TBS
- Article: How to Measure a Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Stability Control for Heavy Duty Vehicles
- Article: Brake Controller Installation on a Ford Super Duty Truck (2005-2007)
- Article: Trailer Tire Sizing
- Article: Trailer Hitch Receiver Sizes