Weight Distribution For A 2015 Chevrolet Traverse Pulling A 2660lb Trailer With 360lb Tongue Weight

Question:

Looking at WD/sway control Fastway e2, 4,500 lb. GTW for my 2015 Traverse. It doesnt appear the shank extends far enough out to clear the back bumper with only 3 3/4 between pin hole and where the triangular support bracket starts. I believe the shaft would have to go up, as I have about 14 coupler height. My trlr weight is 2660, TW is 360 lb. Suggestions?

asked by: Karen B

Expert Reply:

Adding a weight distribution setup to your 2015 Chevrolet Traverse is a great idea. It is going to make your ride quality much better when towing. If your GVW on your trailer is 2660lbs and the tongue weight is 360lbs I recommend the Fastway e2 Weight Distribution w/ 2-Point Sway Control - Trunnion - 6,000 lbs GTW, 600 lbs TW Item # FA92-00-0600.

This weight distribution setup allows backing and is designed for campers with a tongue weight between 250lbs and 600lbs. With the maximum GTW being 6000lbs, you will be covered when adding cargo to your camper. The shank can be used in either the drop or rise position with a total of 7-1/2" of adjustability. The measurement on hitches we offer and install for that vehicle, from the center of the hitch pin hole to the outer most part of the fascia, is about 5-1/4" so you should have plenty of room between the triangular bracket and fascia.

This kit comes with the shank however, it is going to require a ball. I recommend the 2" Hitch Ball - w/ 1" Rise - 1-1/4" Diameter x 2-1/2" Long Shank - Zinc - 6K Item # CB28Z

expert reply by: Shane H