Invisibrake Activates on Jeep When Started But Not Connected to Motorhome
Question:
I recently installed the instibrake on my 2020 jeep and everything worked fine until a week later while not hooked up to the motorhome the instibrake activated. What could of made the brakes activate when the jeep was started?
asked by: Ronald M
Expert Reply:
I discussed your issue with both my in-house installers and technical support at Roadmaster and they both came up with the same concerns. It is likely moisture and/or corrosion at the multi-pin connector at the front of your Jeep.
I have attached a picture of a typical connector and would like you to note that it has a plate that attaches with 2 screws and a rubber boot behind it. If you take off the screws and pull it out, then pull the boot back you will expose the area where the individual pins are connected. In there you must eradicate any moisture or corrosion you find. If any moisture causes a short between pins you could have the problem described.
It would be worthwhile to inspect the connections at your tail lights as well. Since it has been working correctly for a while it is unlikely to be that your inline diodes are backwards and allowing any back feeding into the system.
Product Page this Question was Asked From
Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Tow Bar Braking Systems
- Brake Systems
- Pre-Set System
- One Time Set-Up
- Fixed System
- Power Assist Brake Compatible
- Air Brakes
- Hydraulic Brakes
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Base Plate for Tow Bar
- Shop: etrailer Invisible Base Plate Kit - Removable Arms
- Shop: Vehicle Tow Bar Brake System
- Shop: Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Shop: Trailer Wiring
- Search Results: trailer hitch wiring
- Shop: Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Search Results: tow bar
- Shop: Vehicle Tow Bar Wiring
- Q&A: Using the InvisiBrake Supplemental Braking System Without Using the Brake Lights
- Q&A: Install Video For Roadmaster InvisiBrake in a Jeep Wrangler
- Video: Hopkins Custom Tail Light Wiring Kit Installation - 2004 Jeep Wrangler
- Video: Hopkins Custom Fit Vehicle Wiring - Trailer Hitch Wiring - 42615 Review
- Video: Demco Tow Bar Storage Cover Review
- Search Results: tow bar braking systems
- Search Results: brake systems
- Search Results: base plates
- Shop: Brake Buddy Stealth Supplemental Braking System - Proportional
- Shop: etrailer XHD Non-Binding Tow Bar for Roadmaster Direct-Connect Base Plate - RV Mount - 10,500 lbs
- Q&A: Troubleshooting Issues With A Brake Buddy Stealth Supplemental Braking Systems
- Shop: Hopkins Custom Tail Light Wiring Kit for Towed Vehicles
- Shop: Hopkins Fold-Over Mounting Bracket for 4-Way Flat Trailer Connector
- Shop: Windshield Covers
- Search Results: tow bar cover
- Search Results: tow bar covers
- Shop: Spare Tire Cover
- Video: Trailer Wiring Harness Installation - 2004 Jeep Wrangler
- Q&A: Determining Braking Pressure on Roadmaster InvisiBrake Supplemental Braking System # RM-8700
- Video: etrailer XHD Non-Binding Tow Bar Review e94ZR
- Video: Review of etrailer XHD Tow Bar - Hitch Mount Style - e94ZR