Installation Instructions For Curt Quick Goose 2 Gooseneck Hitch with Installation Kit
Question:
I just received my curt double locking under the bed hitch. all the parts are there but there were no instructions. i was able to figure it out with all the great videos you have on the website. the only thing i would like measurements for is the 4 in hole in the bed. I have a 8ft 2002 f 250 . thanks
asked by: Daniel R
Expert Reply:
I have attached the instructions for your Curt Quick Goose 2 Gooseneck Hitch with Installation Kit # C640-644 for you.
The instruction manual states you will need to measure from the tail gate end of the truck bed. Do this by hooking a tape measure over the back of the truck box and marking the correct location. Next, mark the center between the wheel wells. This marks the center point for the drill hole. This hole location is critical for the correct installation of this hitch. Measure, mark, and saw carefully. This location will put the ball 4"- 6" in front of the axle.
The correct measurement for your 2002 Ford F-250 Super Duty with an 8 foot bed is 48 1/4", and add 1/8 to 3/16 inch to the measurement if your truck has a spray in bed liner.
Please make sure you thoroughly read the instruction manuals before drilling any holes In your vehicle.
I included a video of Curt # C640-644 being installed for you to take a look at.
