How To Attach Loose Wires to Class T Fuse Block for Go Power Inverter
Question:
I have 3/8L” ends on my cables which are 2/0 cables how do you attach to your class T fuse holders? Looks like they only take bare wire. Thx
asked by: Paul L
Helpful Expert Reply:
In order to attach your battery cables to the Go Power Inverter Fuse with Block - Class T - 300 Amp # 34244227REVA, you'll just need some ring terminals like the Spectro Ring Terminal - 2/0 Gauge - 3/8" Ring ID - Copper - Zinc Plated - Qty 1 # SWC57048Z. This ring terminal is designed for 2/0 gauge wiring like you've got and you'll just use the included nuts with the Go Power Inverter Fuse with Block to hold the ring terminals on the posts.
Products Referenced in This Question
Spectro Ring Terminal - 2/0 Gauge - 3/8" Ring ID - Copper - Zinc Plated - Qty 1
- Wiring
- Wire Connectors
- Ring Terminals
- 3/8 Inch Diameter
- 2/0 Gauge
- Spectro
more information >
Product Page this Question was Asked From
Go Power Inverter Fuse with Block - Class T - 300 Amp
- Accessories and Parts
- RV Inverters
- Fuses
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Roadmaster Steering Stabilizer Fit on 2022 Thor Outlaw 29J Motorhome on Ford E450 Chassis
- Q&A: Recommended Square Bulldog Jack with 5,000 lb Capacity
- Q&A: Roof Opening Dimensions For Installing RV Air Conditioner
- Q&A: Repair Kit for Venture Landing Gear Lead or Follower Legs 900-40RU
- Q&A: Progressive Dynamics Power Converter PD4045KA Replacement Converter Section
- Q&A: How to Connect two 12 Volt Batteries and Still have 12 Volts Output
- Q&A: Recommended Trailer Jack For Jet Ski Trailer
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Article: 4 Common Myths About RV Solar Power
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: What is Boondocking
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How Much Solar Power Do I Need For My RV?
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips