Mounting Hole Dimensions for JR Products Door Catch 37270505
Question:
I’d like to replace catches with these but cannot find screw spacing. I originally used AP Products 013-019 and hope to use same holes all drilled in fiberglass. What is the screw spacing on the JR Products # 37270505?
asked by: Dennis
0
Expert Reply:
I had our warehouse measure the JR Products RV Cabinet Catch and Strikes # 37270505 you mentioned. The mounting holes on the latrger catch are 1" apart center to center, and the smaller brackets measure 1-1/8" center to center as shown in the included diagram.
I included a video of the # 37270505 for you to take a look at.
expert reply by:
Samuel C
0
Product Page this Question was Asked From
Continue Researching
- Shop: RV Cabinet Catch and Strikes
- Video: Review of JR Products RV Kitchen - Housewares - 37270505
- Shop: RV Cabinet Catch and Strikes
- Article: Converting Your RV Water Heater to Tankless
- Q&A: What Would Cause Two RV Roof Vent Lid Motors to Not Be Able to Lift Lid
- Q&A: Roof Rack Recommendations for a Palomino SS 550 Pop Up Slide-In Truck Bed Camper
- Q&A: How to Get to Replacement Lift Motor on MaxxFan RV Vent
- Q&A: Recommended Sewer Hose Storage For Hose That Wont Fit In Trailer Bumper
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Don't Break Your Pipes or Your Wallet: Winterize and De-Winterize Your RV
- Q&A: Replacement Slide-Out Motor for Power Gear 523725
- Q&A: Mounting Measurements for Lippert Manual Pull-Out Step LC432690
- Q&A: Replacement Lippert Triple Pull Out/Manual RV Steps
- Article: What is Overlanding? How to Start your Overlanding Journey
- Article: Trailer Wiring Diagrams
- Article: How (and Where) to Connect an RV Propane Grill
- Article: How to Install a Weight Distribution Hitch (With Pictures & Video)