Running Board Replacement Pad for a 2006 Dodge Ram Pickup
Question:
I am looking for a replacement pad for my running boards/nerf bars. They have an image that says TDC. The running boards have no other markings? The existing 3 pads measure-24”’ long, 3-3/34”wide, with 4pins. The length of the oval tube is 8’/ 96” long. The pins are spaces from first pin, 6-1/4” then 8-1/2, then 6-1/4” for the last pin. I sure hope someone can help, as rain is coming , and I would rather not use anti-skid tape for a solution.. I also have a picture of the existing pads
asked by: Dale A
Expert Reply:
We have a solution for your running boards.
We do not carry the TDC custom boards, and unfortunately, the replacement pads we do carry do not match your pin measurements.
However, we do carry the TowSmart SmartStep Non-Slip Pad, part # 348780. This pad does not use pins to secure to the board. Rather, it uses an adhesive to stick to the running board and can be cut to conform to the shape you need. They are 4 inches wide, so they can fit your running boards' width. They are 17.5 inches long, so you may need two of them if you want to cover the full length.
I've included a video review of this pad for your consideration.
Products Referenced in This Question
TowSmart SmartStep Non-Slip Pad - Rubber w/ Adhesive Backing - 17-1/2" Long x 4" Wide
- Accessories and Parts
- Bumper
- Nerf Bars - Running Boards
- Step Pad
- TowSmart
more information >
Product Page this Question was Asked From
TowSmart SmartStep Non-Slip Pad - Rubber w/ Adhesive Backing - 17-1/2" Long x 4" Wide
- Accessories and Parts
- Bumper
- Nerf Bars - Running Boards
- Step Pad
- TowSmart
more information >
Continue Researching
- Q&A: Recommended Replacement Steps For A Kwikee Part Number 903209000 Step Assembly
- Q&A: Replacement Microwave for my High Pointe EC942K9E in Stainless
- Q&A: Recommended Replacement For An Atwood GCH6A-10 E S RV Water Heater
- Q&A: Correct Pull Out Steps For 25.5" Mounting Bracket Width
- Q&A: 3 Step RV Step Replacement Solution for Brackets 25-1/2 inches in Width
- Q&A: Recommended Weather Resistant Non-Slip Rubber Pad For RV Steps, Bumpers, And Ladder Rungs
- Q&A: Suitability of Draw-Tite Class I Receiver Part # 24631 for 1998 Jeep Wrangler with C Channel Bumper
- Article: Performance Chips and Modules