Replacement Fulton Round, Snap-Ring Swivel Marine Jack # FTJ120W030
Question:
Looking For Replacement Shelby 5776 Trailer Jack Without Removing Mounting Plate.
asked by: Shawn
0
Expert Reply:
You don't have to remove the mounting plate if you're wanting to replace just the Fulton Round, Snap-Ring Swivel Marine Jack # FTJ120W0301, but you will get one with the kit so you'll have an extra. We do not sell just the jack only a couple replacement parts. You just need to have a tool to release the snap ring to remove the jack.
If you grab another jack # FTJ120W0301 it will come with everything you need to replace and a bit more.
expert reply by:
Adam E
0
Product Page this Question was Asked From
Fulton Round, Snap-Ring Swivel Marine Jack - Weld On - Sidewind - 10" Lift - 1,200 lbs
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Continue Researching
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Is There a Replacement for a Shelby Jack 5856A That Uses Existing Bracket
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Trailer Jack Recommendation for Shelby # 5856A
- Q&A: Recommendation to Replace Shelby 5756A Trailer Jack
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Jack for Bulldog Model 130 Marine Jack
- Q&A: Replacement Parts and Winch for a Profile 2000 Hand Winch
- Article: Best Boat Trailer Jacks
- Article: Trailer Jacks
- Article: Trailer Maintenance Schedule
- Article: Pintle-Hitches
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer