Can Ignition Wire of Superwinch LT2000 Run to Main Power Wire
Question:
I saw a reply from Michael h on wiring the red ignition wire to a power source if I’m putting an atv winch on a boat trailer. Can I wire it to the red power terminal on the solenoid.
asked by: Jeff
0
Expert Reply:
The ignition wire of the # 1120210 is an activation circuit that normally is used when installing on an ATV to tell the winch the ATV is on and the winch is powered up. In a boat trailer install situation like you mentioned you could run this circuit to the same place as the main power wire and it will work just fine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Superwinch LT2000 ATV Winch - Wire Rope - Roller Fairlead - 2,000 lbs
- Electric Winch
- ATV - UTV Winch
- 1-Stage Planetary Gear
- 1.0 HP
- 1001 - 2000 lbs
- 11 - 20 lbs
- Slow - 0 to 4 fpm
- No Remote
- Wire Rope
- Superwinch
more information >
Continue Researching
- Q&A: Recommended Electric Winch for Raising and Lowering a Pop Up Camper
- Article: How to Wire an Electric Winch
- Q&A: Powering A Winch In My 2016 Ford Explorer
- Q&A: Finding A Replacement Electric Winch For 2007 Rockwood Popup Camper
- Q&A: Electric Winch Recommendation for Forest River Pop Up Camper
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Can Pop Up Camper Trailer Hand Winch be Replaced with Electric Winch
- Q&A: Installation of the Remote for the Superwinch LT2000
- Q&A: Difference Between an Idler Hub and a Hub/Drum
- Article: Basics of Tie Down Straps
- Article: Trailer Hitch Receiver Sizes